Equipment Design for the Primary Separation of Solids from Wastewater in Swine Companies in Cuba
Abstract
Abstract - In the Work the literature is deepened about the aspects that characterize the generation of residuals in the Pig Farms in general and in particular those that exist in Cuba. Some aspects related to the equipment used in the primary separation of the solids from the waste water of the Swine Companies were reviewed, to select the most appropriate from the point of view of the necessary capacity, economy, simplicity of operation and maintenance, and effectiveness. Ultimately, a Conveyor / Strainer by Endless Screw is selected as the base equipment for the separation, the necessary capacity, its basic dimensions and fundamental operating parameters are calculated and the reduction motor is selected for its operation. Finally, the conveyor shaft is designed and calculated using the elastic foundation beam analysis scheme and the bearings are designed and calculated using a FEROFOM plastic material.Downloads
References
N. Arzola, “Determinación Experimental del Coeficiente de Rigidez del Bagazo”, Ing. Investig., vol. 17, no. 2, pp. 5-10, Ago, 2007. http://www.scielo.org.co/pdf/iei/v27n2/v27n2a01.pdf
J. De Victoria y M. Galván, “Tratamiento y aprovechamiento de aguas residuales de granjas porcinas, primera etapa”, Proyecto 7.2.56. Tratamiento de aguas en zonas industriales urbanas y rurales. Ingeniería Ambiental. México. 2006.
Morales Veraz, J., Barceló Sánchez, T., & Hernández Herrera, H. (2017). Alternativas para la revalorización de los efluentes de la de la Empresa Porcina Cienfuegos. IJMSOR: International Journal of Management Science & Operation Research, 2(1), 22-29. Recuperado a partir de http://ijmsoridi.com/index.php/ijmsor/article/view/83
O. Labahn–Kaminsky, Prontuario del Cemento. La Habana: Ciencia y Técnica, 1970.
Y. Llody, “Nuevos métodos de cálculo y tecnologías de fabricación de los rotores de las bombas de cavidad progresiva”, Tesis de Doctorado, Universidad de Cienfuegos, Cuba, 2011.
D. López, “Nuevo esquema de análisis para el cálculo de las fuerzas internas y los desplazamientos en los rotores de las bombas de cavidad progresiva”, Trabajo de Diploma. UCF, USA, 2009.
G. S. Pisarenko, A. P. Yakovlev y V. K. Matveev, Manual de Resistencia de Materiales. Moscú: Editorial MIR, 1989.
V. S. Shubin y C. Pedré, Diseño de Maquinaria Industrial. La Habana,m CU: Editorial Pueblo y Educación, 1984.
A. Valle, “Diseño y Fabricación de Basculador de 20 t. sobre terreno”, Tesis de Maestría, 2000.
Bertolli, M., Roark, G., Urrutia, S., & Chiodi, F. (2017). Revisión de modelos de madurez en la medición del desempeño. INGE CUC, 13(1), 70-83. https://doi.org/10.17981/ingecuc.13.1.2017.07
Published papers are the exclusive responsibility of their authors and do not necessary reflect the opinions of the editorial committee.
IJMSOR respects the moral rights of its authors, whom must cede the editorial committee the patrimonial rights of the published material. In turn, the authors inform that the current work is unpublished and has not been previously published.
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivs 3.0 Unported License.
